Lucerne won’t start after repairing a section of fuel line and purge valve

[John532054]

Hello, I recently replaced a small section of rusted fuel line in my 07 Lucerne. While cutting out a section near the charcoal canister and purge valve on top of the engine, I accidentally snapped the nylon line that is connected to the purge valve and charcoal canister. It snapped off right where the line feeds into the box with the evap sensor. I pulled another box with the female half of the evap sensor from a 2010 lacrosse because they looked identical. I got everything put together but the car won’t turnover. There are no leaks, the vehicle cranks just won’t turnover. Any help with this issue would be greatly appreciated.

 

[2007LucerneCXL]

Check the fuel pressure to confirm, check if any CEL codes are present. While swapping/repair fuel line should not be a issue something else has occurred and not being on site it's kind of best guessing.