wipers killing me

[tom9]

Please help with wipers won't work!
First its 02 rendz 2w,Cal emissions,sunroof,and bad condition when I got it!
Still is!
I replaced wiper motor and assembly, had checked voltage in connector first and all settings "worked" with volt meter!!!
Now nothing at the connector I did a lot of work.....suspension brakes,egr ,plugs,and still drives..
It cranks with a lot of hesitation that gets "solved" in two minutes and has a blower relay that only works on high.
It had real bad mistreating at the used car place with the brake switch running the battery down ...so.. did jumping the battery over and over there mess up the BCM?
I need a keyless entry remote. Do I change the BCM with matching VIN CODE and set the passlock in setting up the BCM?
I see I need a scantool also!
NEED HELP NEED WIPERS THANKFULL IT RUNS!

 

[typhoonk]

1. Check all fuses - inside and under the hood. Pull them out, then if good seat them back in securely.

2. Pull the battery for a while and see if that resets the data system/ecu

3. don't understand your starting issue.

4. blower motor issue could be the resistor pack or the control board.

5. Search online and getting answers is a skill ->
Programming New and old keyfobs (must program all at once, up to 4 can be done)
-----------------------------------------
1. Close the vehicle doors.
2. Turn OFF the ignition.
3. Remove the ignition key from the ignition lock cylinder.
4. Press and hold the driver side door lock switch to the unlock position.
5. Insert the ignition key into the ignition lock cylinder and remove the key. (Do not turn the ignition key in the lock cylinder.)
6. Insert the ignition key into the ignition lock cylinder and remove the key. (Do not turn the ignition key in the lock cylinder.)
7. Insert the ignition key into the ignition lock cylinder. (Do not turn the ignition key in the lock cylinder.) Leave the ignition key in the ignition lock cylinder.
8. Release the door lock switch. The body control module (BCM) will sound three beeps in order to verify the Program Mode has been activated.
9. Press the lock and unlock buttons on the keyless entry transmitter simultaneously for approximately 5 seconds . The BCM will sound two beeps in order to verify that the transmitter has been successfully programmed.
10. Perform the previous step to program up to four transmitters.
11. Remove the ignition key in order to exit the Program Mode.
12. Verify the proper operation of each transmitter.
-----------------------------------------------------

and if you need a new key programmed that's a cinch too 😉

 

[tom9]

Thankx ,The keyless remote info is right on time!
Will pull all fuses and check!